Routing Extensions for Discovery of Role-based MPLS Label Switching Router (MPLS LSR) Traffic Engineering (TE) Mesh Membership
draft-li-ccamp-role-based-automesh-02

Document Type Expired Internet-Draft (individual)
Last updated 2014-12-19 (latest revision 2014-06-17)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-li-ccamp-role-based-automesh-02.txt

Abstract

A Traffic Engineering (TE) mesh-group is defined as a group of Label Switch Routers (LSRs) that are connected by a full mesh of TE LSPs. Routing (OSPF and IS-IS) extensions for discovery Multiprotocol Label Switching (MPLS) LSR TE mesh membership has been defined to automate the creation of mesh of TE LSPs. This document introduces a role-based TE mesh-group that applies to the scenarios where full mesh TE LSPs is not necessary and TE LSPs setup depends on the roles of LSRs in a TE mesh-group. Interior Gateway Protocol (IGP) routing extensions for automatic discovery of role-based TE mesh membership are defined accordingly.

Authors

Zhenbin Li (lizhenbin@huawei.com)
Mach Chen (mach.chen@huawei.com)
Gregory Mirsky (gregory.mirsky@ericsson.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)