Routing Extensions for Discovery of Role-based MPLS Label Switching Router (MPLS LSR) Traffic Engineering (TE) Mesh Membership
draft-li-ccamp-role-based-automesh-00
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
|
|
|---|---|---|---|
| Authors | Zhenbin Li , Mach Chen | ||
| Last updated | 2013-08-21 (Latest revision 2013-02-17) | ||
| RFC stream | (None) | ||
| Formats | |||
| Additional resources | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
A Traffic Engnieering (TE) mesh-group is defined as a group of Label Switch Routers (LSRs) that are connected by a full mesh of TE LSPs. Routing (OSPF and IS-IS) extensions for discovery Multiprotocol Label Switching (MPLS) LSR TE mesh membership has been defined to automate the creation of mesh of TE LSPs. This document introduces a role-based TE mesh-group that applies to the scenarios where full mesh TE LSPs are not necessary and TE LSPs setup depends on the roles of LSRs in a TE mesh-group. Interior Gateway Protocol (IGP) routing extensions for automatic discovery of role-based TE mesh membership are defined accordingly.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)