Interface VLAN YANG Data Models
draft-wilton-intf-vlan-yang-00
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Robert Wilton , David Ball , Giles Heron | ||
Last updated | 2015-07-07 (Latest revision 2015-03-09) | ||
Replaced by | draft-wilton-netmod-intf-vlan-yang | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-wilton-netmod-intf-vlan-yang | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document defines a YANG configuration data model for the management of VLAN sub-interfaces that augments the generic interfaces data model defined in RFC 7223 [RFC7223]. It provides support for basic tag matching to allow termination of an L2 VLAN segement into L3 services. It also provides support for flexible matching and rewriting of L2 header fields for L2 services. The model differs from an IEEE 802.1Q VLAN derived model in that the configuration is interface/sub-interface based as opposed to being VLAN based.
Authors
Robert Wilton
David Ball
Giles Heron
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)