Shim6 Reachability Detection
draft-van-beijnum-shim6-reach-detect-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Iljitsch van Beijnum | ||
Last updated | 2006-06-30 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The shim6 working group is developing a mechanism that allows multihoming by using multiple addresses. When communication between the initially chosen addresses for a transport session is no longer possible, a "shim" layer makes it possible to switch to a different set of addresses without breaking current transport protocol assumptions. This draft discusses the issues of detecting failures in a currently used address pair between two hosts ("current pair reachability") and and picking a new address pair to be used when a failure occurs ("full path exploration").
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)