IP RSVP-TE: Extensions to RSVP for P2P IP-TE LSP Tunnels
draft-saad-teas-rsvpte-ip-tunnels-01

Document Type Expired Internet-Draft (individual)
Last updated 2020-05-07 (latest revision 2019-11-04)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-saad-teas-rsvpte-ip-tunnels-01.txt

Abstract

This document describes the use of RSVP (Resource Reservation Protocol), including all the necessary extensions, to establish Point-to-Point (P2P) Traffic Engineered IP (IP-TE) Label Switched Path (LSP) tunnel(s) for use in native IP forwarding networks. This document proposes specific extensions to the RSVP protocol to allow the establishment of explicitly routed IP paths using RSVP as the signaling protocol. The result is the instantiation of an IP Path which can be automatically routed away from network failures, congestion, and bottlenecks.

Authors

Tarek Saad (tsaad@juniper.net)
Vishnu Beeram (vbeeram@juniper.net)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)