Establishing Point to Multipoint MPLS TE LSPs
draft-raggarwa-mpls-p2mp-te-02
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Rahul Aggarwal | ||
| Last updated | 2004-02-11 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a solution for point to multipoint (P2MP) Traffic Engineering (TE). The objective is to optimize packet replication and minimize state and intelligence in the core of the network, while performing P2MP TE. The solution relies on RSVP-TE in the core of the network. It is based on setting up a P2MP LSP by merging P2P LSPs in the network. The setup of P2P LSPs is source intiated. Simple enhancements are made to RSVP-TE to facilitate the set up of a P2MP TE LSP. There is no need to run a multicast routing protocol in the network core. There can be various applications for P2MP TE LSPs such as multicast. Specification of how such applications will use a P2MP LSP is outside the scope of this document.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)