Additional Diffie-Hellman Groups for Use with IETF Standards
draft-lepinski-rfc5114-bis-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Matt Lepinski , Stephen Kent | ||
| Last updated | 2011-06-29 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes eight Diffie-Hellman groups that can be used in conjunction with IETF protocols to provide security for Internet communications. The groups allow implementers to use the same groups with a variety of security protocols, e.g., SMIME, Secure Shell (SSH), Transport Layer Security (TLS), and Internet Key Exchange (IKE). All of these groups comply in form and structure with relevant standards from ISO, ANSI, NIST, and the IEEE. These groups are compatible with all IETF standards that make use of Diffie-Hellman or Elliptic Curve Diffie-Hellman cryptography. These groups and the associated test data are defined by NIST on their web site [EX80056A], but have not yet (as of this writing) been published in a formal NIST document. Publication of these groups and associated test data, as well as describing how to use Diffie-Hellman and Elliptic Curve Diffie-Hellman for key agreement in all of the protocols cited below, in one RFC, will facilitate development of interoperable implementations and support the Federal Information Processing Standard (FIPS) validation of implementations that make use of these groups.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)