Service Provider Requirements for Ethernet control with GMPLS
draft-imajuku-ccamp-ethernet-gmpls-req-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Wataru Imajuku | ||
Last updated | 2007-11-20 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Generalized Multi-Protocol Label Switching (GMPLS) is applicable to Ethernet switches supporting Provider Backbone Bridge Traffic Engineering (PBB-TE) networks. The GMPLS controlled Ethernet label switch network not only automates creation of Ethernet Label Switched Paths(Eth-LSPs), it also provides sophisticated Eth-LSP recovery Mechanisms such as protection and restoration of an Eth-LSP. This document describes the requirements for the set of solutions of GMPLS controlled Ethernet label switch networks.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)