Control Messages Protocol for Use with Network Time Protocol Version 4
draft-ietf-ntp-mode-6-cmds-05

The information below is for an old version of the document
Document Type Expired Internet-Draft (ntp WG)
Authors David Mills  , Brian Haberman 
Last updated 2018-09-27 (latest revision 2018-03-26)
Replaces draft-haberman-ntpwg-mode-6-cmds
Stream IETF
Intended RFC status Informational
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Reviews
Additional Resources
- Mailing list discussion
Stream WG state WG Consensus: Waiting for Write-Up
Document shepherd No shepherd assigned
IESG IESG state Expired
Consensus Boilerplate Yes
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-ntp-mode-6-cmds-05.txt

Abstract

This document describes the structure of the control messages used with the Network Time Protocol. These control messages can be used to monitor and control the Network Time Protocol application running on any IP network attached computer. The information in this document was originally described in Appendix B of RFC 1305. The goal of this document is to provide a historic description of the control messages as described in RFC 1305 and any additional commands implemented in NTP.

Authors

David Mills (mills@udel.edu)
Brian Haberman (brian@innovationslab.net)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)