mLDP Node Protection

The information below is for an old version of the document
Document Type Expired Internet-Draft (mpls WG)
Authors IJsbrand Wijnands  , Eric Rosen  , Kamran Raza  , Jeff Tantsura  , Alia Atlas  , Quintin Zhao 
Last updated 2014-02-07 (latest revision 2013-08-06)
Replaces draft-wijnands-mpls-mldp-node-protection
Stream IETF
Intended RFC status (None)
Expired & archived
pdf htmlized (tools) htmlized bibtex
Additional Resources
- Mailing list discussion
Stream WG state WG Document
Document shepherd None
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


This document describes procedures to support node protection for Point-to-Multipoint and Multipoint-to-Multipoint Label Switched Paths (MP LSPs) built by LDP ("Label Distribution Protocol"), or simply mLDP. In order to protect a node N, the Point of Local Repair (PLR) LSR of N must learn the Merge Point (MPT) LSR(s) of node N such that traffic can be redirected to them in case node N fails. Redirecting the traffic around the failed node N depends on existing P2P LSPs originated from the PLR LSR to the MPT LSRs while bypassing LSR node N.


IJsbrand Wijnands (
Eric Rosen (
Kamran Raza (
Jeff Tantsura (
Alia Atlas (
Quintin Zhao (

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)