Mobile IPv6 Operation with IKEv2 and the Revised IPsec Architecture
Draft of message to be sent after approval:
From: The IESG <email@example.com> To: IETF-Announce <firstname.lastname@example.org> Cc: Internet Architecture Board <email@example.com>, RFC Editor <firstname.lastname@example.org>, mip6 mailing list <email@example.com>, mip6 chair <firstname.lastname@example.org> Subject: Protocol Action: 'Mobile IPv6 Operation with IKEv2 and the revised IPsec Architecture' to Proposed Standard The IESG has approved the following document: - 'Mobile IPv6 Operation with IKEv2 and the revised IPsec Architecture ' <draft-ietf-mip6-ikev2-ipsec-09.txt> as a Proposed Standard This document is the product of the Mobility for IPv6 Working Group. The IESG contact persons are Jari Arkko and Mark Townsley. A URL of this Internet-Draft is: http://www.ietf.org/internet-drafts/draft-ietf-mip6-ikev2-ipsec-09.txt
Technical Summary This document describes Mobile IPv6 operation with the revised IPsec architecture and IKEv2. The MIP6 RFCs 3775 and 3776 are based on IKE. This I-D explains MIP6 operation and establishment of the IPsec SA between the MN and HA using IKEv2. Working Group Summary The WG has been keen on ensuring a solution for MIP6 with IKEv2 is specified. There is overall consensus on the need for this specification and is widely supported. This I-D has undergone two WG last calls and has been discussed at several MIP6 WG meetings. Protocol Quality This specification has been reviewed by Jari Arkko for the IESG. AD review revealed a concern that the specification of IPsec policies might not be fully RFC 4301 compliant. The IETF Last Call period was used to work together with the secdir to look into this. Extensive comments were received, and document was revised accordingly.