Diameter Applications Design Guidelines

The information below is for an old version of the document
Document Type Expired Internet-Draft (dime WG)
Authors Lionel Morand  , Victor Fajardo  , Hannes Tschofenig 
Last updated 2013-04-24 (latest revision 2012-10-21)
Replaces draft-fajardo-dime-app-design-guide
Stream IETF
Intended RFC status (None)
Expired & archived
pdf htmlized (tools) htmlized bibtex
Additional Resources
- Mailing list discussion
Stream WG state WG Consensus: Waiting for Write-Up
Document shepherd Jouni Korhonen
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


The Diameter Base protocol provides facilities for protocol extensibility enabling to define new Diameter applications or modify existing applications. This document is a companion document to the Diameter base protocol that further explains and clarifies the rules to extend the Diameter base protocol. It is meant as a guidelines document and therefore it does not add, remove or change existing rules.


Lionel Morand (lionel.morand@orange.com)
Victor Fajardo (vf0213@gmail.com)
Hannes Tschofenig (Hannes.Tschofenig@gmx.net)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)