Drone Remote Identification Protocol (DRIP) Architecture
draft-card-drip-arch-02

Document Type Replaced Internet-Draft (drip WG)
Last updated 2020-05-12 (latest revision 2020-04-20)
Replaces draft-card-tmrid-uas-arch
Replaced by draft-ietf-drip-arch
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream WG state Adopted by a WG
Document shepherd No shepherd assigned
IESG IESG state Replaced by draft-ietf-drip-arch
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-card-drip-arch-02.txt

Abstract

This document defines an architecture for Drone Remote Identification Protocol (DRIP) Working Group protocols and services to support Unmanned Aircraft System Remote Identification (UAS RID) and RID- related communications, including its building blocks and their interfaces, all to be standardized. CAVEAT LECTOR: This draft version is undergoing substantial restructuring and is submitted to the DRIP WG only to spark discussion on architecture and to be adopted as a placeholder if there is consensus that there should be an architecture document (however far from any future consensus on that architecture this draft may be).

Authors

Stuart Card (stu.card@axenterprize.com)
Adam Wiethuechter (adam.wiethuechter@axenterprize.com)
Robert Moskowitz (rgm@labs.htt-consult.com)
Shuai Zhao (shuaiizhao@tencent.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)