Label Distribution Protocol Extensions for Half-Duplex Multipoint-to-Multipoint Label Switched Paths
draft-brockners-ldp-half-duplex-mp2mp-02

Document Type Expired Internet-Draft (individual)
Last updated 2008-02-22
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-brockners-ldp-half-duplex-mp2mp-02.txt

Abstract

This document describes a mechanism to construct Label Switched Paths (LSP) over MPLS using an extended version of the Label Distribution Protocol (LDP) between a set of clients and servers. This communication mechanism has the capability that servers can communicate with other servers and clients, whereas clients can only communicate with servers but not with other clients. Conventions used in this document The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC-2119.

Authors

Frank Brockners (fbrockne@cisco.com)
IJsbrand Wijnands (iwijnand@cisco.com)
Ali Sajassi (sajassi@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)