OSPFv3 as a Provider Edge to Customer Edge (PE-CE) Routing Protocol
RFC 6565

Note: This ballot was opened for revision 11 and is now closed.

(Stewart Bryant) Yes

(Adrian Farrel) Yes

Comment (2009-12-15 for -** No value found for 'p.get_dochistory.rev' **)
No email
send info
[BGP-EXTCOMM-IPV6] should be [RFC5701] and should probably be a
Normative Reference.

(Jari Arkko) No Objection

Comment (2011-12-14 for -** No value found for 'p.get_dochistory.rev' **)
No email
send info
+1 to comments from Fred Baker and Dan Romascanu

(Ron Bonica) No Objection

(Gonzalo Camarillo) No Objection

(Ralph Droms) No Objection

(Wesley Eddy) No Objection

(Stephen Farrell) No Objection

Comment (2011-12-13 for -** No value found for 'p.get_dochistory.rev' **)
No email
send info
- Who's the document shepherd? Tracker note says Ben, iesg writeup
says Danny. Probably a typo somewhere or a change, but might be worth

- The abstract is confusing. It says "We had BGP/MPLS for IPv4; then
we added IPv6; then we added OSPFv2 and now in this document, we add
OSPFv3." Telling the reader about IPv4/IPv6 just seems distracting

- NLRI & NSSA not expanded on 1st use. 

- Is it safe to use a NULL domain ID? If I do that then
an incoming message can easily be confusing? 

- Section 7 refers to rfc 4659 section 11 and 4577 section 6.
4659 section 11 refers to 2545 section 5 and 4364 section 13.
4577 refers to 4364 and 4365.
2545 says "nothing new here."
4364 is updated by 4577, 4684 and 5462.
4577 says "cryptographic authentication" SHOULD be used and
MUST be implemented but doesn't say what "cryptographic
authentication" really means.
I stopped following the breadcrumbs at that point;-)
Can't we do this better and simpler?

(Russ Housley) No Objection

(Pete Resnick) No Objection

(Dan Romascanu) No Objection

Comment (2011-12-14 for -** No value found for 'p.get_dochistory.rev' **)
No email
send info
Fred Baker made in his OPS-DIR review a couple of comments which are not show stoppers but deserve being answered and clarified if necessary in the text: 

1. The introduction mentions the use of OSPFv2 for IPv4 and OSPFv3 for IPv6. With the advent of OSPFv3 address families, mentioned in section 6, it is possible to use OSPFv3 for IPv4, enabling one protocol and one configuration to be used for both network layer protocols. I would expect that this might be a useful thing to comment on in the introduction.

2. The one question I was left asking was why the document mentioned MPLS in 20 places but did nothing with MPLS other than mention that it was used in BGP/MPLS VPNs. The routing technology could just as easily be used on any other PE-CE link; the point is that it is between an OSPFv3 instance in the PE and a correspondent on the CE router, enabling a customer to communicate with an upstream in a manner that enabled the upstream to trust routing information without the customer needing to obtain an AS number and operate a BGP configuration. That's not an impediment; the document only chose to specify that configuration. But the narrowness of specification left me puzzled.

(Peter Saint-Andre) No Objection

(Robert Sparks) No Objection

(Sean Turner) No Objection

(Ross Callon) No Record

(Lisa Dusseault) No Record

Lars Eggert No Record

(Pasi Eronen) No Record

(Cullen Jennings) No Record

(Magnus Westerlund) No Record