Using IPsec to Protect Mobile IPv6 Signaling Between Mobile Nodes and Home Agents
Draft of message to be sent after approval:
From: The IESG <email@example.com> To: IETF-Announce <firstname.lastname@example.org> Cc: Internet Architecture Board <email@example.com>, RFC Editor <firstname.lastname@example.org>, mip6 mailing list <email@example.com>, mip6 chair <firstname.lastname@example.org> Subject: Protocol Action: 'Using IPsec to Protect Mobile IPv6 Signaling between Mobile Nodes and Home Agents' to Proposed Standard The IESG has approved the following document: - 'Using IPsec to Protect Mobile IPv6 Signaling between Mobile Nodes and Home Agents ' <draft-ietf-mobileip-mipv6-ha-ipsec-07.txt> as a Proposed Standard This document is the product of the Mobility for IPv6 Working Group. The IESG contact persons are Thomas Narten and Mark Townsley. A URL of this Internet-Draft is: http://www.ietf.org/internet-drafts/draft-ietf-mobileip-mipv6-ha-ipsec-07.txt
Technical Summary Mobile IPv6 uses IPsec to protect signaling between the home agent and the mobile node. The mobile IPv6 base document defines the main requirements these nodes must follow. This document discusses these requirements in more depth, illustrates the used packet formats, describes suitable configuration procedures, and shows how implementations can process the packets in the right order. Working Group Summary There was support for this document in the WG. Protocol Quality This document has been reviewed for the IESG by Thomas Narten. RFC Editor Note: Delete the following sentence from the Introduction: Note that in addition to the use of ESP as specified here, it may also be possible to use Authentication Header (AH) , but for brevity this is not discussed in this specification. Also, reference  should be moved from the "Normative References" Section to the "Informative References" section.