Applicability Statement for the Implementation of Classless Inter-Domain Routing (CIDR)
RFC 1517

Document Type RFC - Historic (September 1993; Errata)
Last updated 2013-03-02
Stream IETF
Formats plain text pdf htmlized with errata bibtex
Stream WG state (None)
Document shepherd No shepherd assigned
IESG IESG state RFC 1517 (Historic)
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)
Network Working Group                Internet Engineering Steering Group
Request for Comments: 1517                             R. Hinden, Editor
Category: Standards Track                                 September 1993

           Applicability Statement for the Implementation of
                 Classless Inter-Domain Routing (CIDR)

Status of this Memo

   This RFC specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" for the standardization state and status
   of this protocol.  Distribution of this memo is unlimited.

1.   Introduction

   As the Internet has evolved and grown in recent years, it has become
   clear that it will soon face several serious scaling problems. These

      - Exhaustion of the class-B network address space. One
        fundamental cause of this problem is the lack of a network
        class of a size that is appropriate for a mid-sized
        organization. Class-C, with a maximum of 254 host addresses, is
        too small, while class-B, which allows up to 65534 addresses,
        is too large to be densely populated.  The result is inefficient
        utilization of class-B network numbers.

      - Routing information overload. The size and rate of growth of the
        routing tables in Internet routers is beyond the ability of
        current software (and people) to effectively manage.

      - Eventual exhaustion of IP network numbers.

   It has become clear that the first two of these problems are likely
   to become critical in the near term.  Classless Inter-Domain Routing
   (CIDR) ttempts to deal with these problems by defining a mechanism to
   slow the growth of routing tables and reduce the need to allocate new
   IP network numbers.  It does not attempt to solve the third problem,
   which is of a more long-term nature, but instead endeavors to ease
   enough of the short to mid-term difficulties to allow the Internet to
   continue to function efficiently while progress is made on a longer-
   term solution.

   The IESG, after a thorough discussion in the IETF, in June 1992
   selected CIDR as the solution for the short term routing table

IESG                                                            [Page 1]
RFC 1517              CIDR Applicability Statement        September 1993

   explosion problem [1].

2. Components of the Architecture

   The CIDR architecture is described in the following documents:

      - "An Architecture for IP Address Allocation with CIDR" [2]

      - "Classless Inter-Domain Routing (CIDR):  An Address Assignment
        and Aggregation Strategy" [3]

   The first of these documents presents the overall architecture of
   CIDR; the second describes the specific address allocation scheme to
   be used.

   In addition to these two documents, "Guidelines for Management of IP
   Address Space" [4] provides specific recommendations for assigning IP
   addresses that are consistent with [2] and [3], and "Status of CIDR
   Deployment in the Internet" [5] describes the timetable for deploying
   [4] in the Internet.  Both [4] and [5] should be viewed as
   supporting, rather than defining, documents.

   In addition to the documents mentioned above, CIDR requires that
   inter-domain routing protocols be capable of handling reachability
   information that is expressed solely in terms of IP address prefixes.
   While several inter-domain routing protocols are capable of
   supporting such functionality, this Applicability Statement does not
   mandate the use of a particular one.

   Although Internet routing domains are not required to use routing
   protocols capable of propagating CIDR routes, the topology such
   routing domains can support will be somewhat limited.  In particular,
   the non-CIDR-capable parts of the Internet will need to default
   towards the CIDR-capable parts of the Internet for routes which have
   been aggregated to non-network boundaries.

3. Applicability of CIDR

   The CIDR architecture is applicable to any group of connected domains
   that supports IP version 4 [6] [7].  CIDR does not require all of the
   domains in the Internet to be converted to use CIDR. It assumes that
   some of the existing domains in the Internet will never be able to
   convert.  Despite this, CIDR will still provide connectivity to such
   places, although the optimality of routes to these places may be

   This Applicability Statement requires Internet domains providing
   backbone and/or transit service to fully implement CIDR in order to

IESG                                                            [Page 2]
RFC 1517              CIDR Applicability Statement        September 1993

   ensure that the growth of the resources required by routers to
   provide Internet-wide connectivity will be significantly slower than
Show full document text