TCP Extension for High-Speed Paths
RFC 1185

Document Type RFC - Experimental (October 1990; No errata)
Obsoleted by RFC 1323
Authors Lixia Zhang  , Robert Braden  , Van Jacobson 
Last updated 2013-03-02
Stream Legacy stream
Formats plain text html pdf htmlized (tools) htmlized bibtex
Stream Legacy state (None)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state RFC 1185 (Experimental)
Telechat date
Responsible AD (None)
Send notices to (None)
Network Working Group                                        V. Jacobson
Request for Comments: 1185                                           LBL
                                                               R. Braden
                                                                L. Zhang
                                                            October 1990

                   TCP Extension for High-Speed Paths

Status of This Memo

   This memo describes an Experimental Protocol extension to TCP for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "IAB
   Official Protocol Standards" for the standardization state and status
   of this protocol.  Distribution of this memo is unlimited.


   This memo describes a small extension to TCP to support reliable
   operation over very high-speed paths, using sender timestamps
   transmitted using the TCP Echo option proposed in RFC-1072.


   TCP uses positive acknowledgments and retransmissions to provide
   reliable end-to-end delivery over a full-duplex virtual circuit
   called a connection [Postel81].  A connection is defined by its two
   end points; each end point is a "socket", i.e., a (host,port) pair.
   To protect against data corruption, TCP uses an end-to-end checksum.
   Duplication and reordering are handled using a fine-grained sequence
   number space, with each octet receiving a distinct sequence number.

   The TCP protocol [Postel81] was designed to operate reliably over
   almost any transmission medium regardless of transmission rate,
   delay, corruption, duplication, or reordering of segments.  In
   practice, proper TCP implementations have demonstrated remarkable
   robustness in adapting to a wide range of network characteristics.
   For example, TCP implementations currently adapt to transfer rates in
   the range of 100 bps to 10**7 bps and round-trip delays in the range
   1 ms to 100 seconds.

   However, the introduction of fiber optics is resulting in ever-higher
   transmission speeds, and the fastest paths are moving out of the
   domain for which TCP was originally engineered.  This memo and RFC-
   1072 [Jacobson88] propose modest extensions to TCP to extend the

Jacobson, Braden & Zhang                                        [Page 1]
RFC 1185               TCP over High-Speed Paths            October 1990

   domain of its application to higher speeds.

   There is no one-line answer to the question: "How fast can TCP go?".
   The issues are reliability and performance, and these depend upon the
   round-trip delay and the maximum time that segments may be queued in
   the Internet, as well as upon the transmission speed.  We must think
   through these relationships very carefully if we are to successfully
   extend TCP's domain.

   TCP performance depends not upon the transfer rate itself, but rather
   upon the product of the transfer rate and the round-trip delay.  This
   "bandwidth*delay product" measures the amount of data that would
   "fill the pipe"; it is the buffer space required at sender and
   receiver to obtain maximum throughput on the TCP connection over the
   path.  RFC-1072 proposed a set of TCP extensions to improve TCP
   efficiency for "LFNs" (long fat networks), i.e., networks with large
   bandwidth*delay products.

   On the other hand, high transfer rate can threaten TCP reliability by
   violating the assumptions behind the TCP mechanism for duplicate
   detection and sequencing.  The present memo specifies a solution for
   this problem, extending TCP reliability to transfer rates well beyond
   the foreseeable upper limit of bandwidth.

   An especially serious kind of error may result from an accidental
   reuse of TCP sequence numbers in data segments.  Suppose that an "old
   duplicate segment", e.g., a duplicate data segment that was delayed
   in Internet queues, was delivered to the receiver at the wrong moment
   so that its sequence numbers fell somewhere within the current
   window.  There would be no checksum failure to warn of the error, and
   the result could be an undetected corruption of the data.  Reception
   of an old duplicate ACK segment at the transmitter could be only
   slightly less serious: it is likely to lock up the connection so that
   no further progress can be made and a RST is required to
   resynchronize the two ends.

   Duplication of sequence numbers might happen in either of two ways:

   (1)  Sequence number wrap-around on the current connection

        A TCP sequence number contains 32 bits.  At a high enough
        transfer rate, the 32-bit sequence space may be "wrapped"
        (cycled) within the time that a segment may be delayed in
        queues.  Section 2 discusses this case and proposes a mechanism
Show full document text