Network Working Group                                          D. Walton
Internet Draft                                                 A. Retana
Intended Status: Standards Track                                 E. Chen
Expiration Date: February 2011                             Cisco Systems
                                                              J. Scudder
                                                        Juniper Networks
                                                          August 9, 2010


                 Advertisement of Multiple Paths in BGP

                    draft-ietf-idr-add-paths-04.txt


Status of this Memo

   This Internet-Draft is submitted to IETF in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF), its areas, and its working groups.  Note that
   other groups may also distribute working documents as Internet-
   Drafts.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time. It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   The list of current Internet-Drafts can be accessed at
   http://www.ietf.org/1id-abstracts.html

   The list of Internet-Draft Shadow Directories can be accessed at
   http://www.ietf.org/shadow.html

   This Internet-Draft will expire on February 10, 2011.

Copyright Notice

   Copyright (c) 2010 IETF Trust and the persons identified as the
   document authors. All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document. Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document. Code Components extracted from this document must



Walton, et al        Expiration Date February 2011              [Page 1]


INTERNET DRAFT      draft-ietf-idr-add-paths-04.txt          August 2010


   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Abstract

   In this document we propose a BGP extension that allows the
   advertisement of multiple paths for the same address prefix without
   the new paths implicitly replacing any previous ones.  The essence of
   the extension is that each path is identified by a path identifier in
   addition to the address prefix.


1. Introduction

   The BGP specification [RFC4271] defines an "Update-Send Process" to
   advertise the routes chosen by the Decision Process to other BGP
   speakers.  No provisions are made to allow the advertisement of
   multiple paths for the same address prefix, or Network Layer
   Reachability Information (NLRI).  In fact, a route with the same NLRI
   as a previously advertised route implicitly replaces the previous
   advertisement.

   In this document we propose a BGP extension that allows the
   advertisement of multiple paths for the same address prefix without
   the new paths implicitly replacing any previous ones.  The essence of
   the extension is that each path is identified by a path identifier in
   addition to the address prefix.


1.1. Specification of Requirements

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [RFC2119].
















Walton, et al        Expiration Date February 2011              [Page 2]


INTERNET DRAFT      draft-ietf-idr-add-paths-04.txt          August 2010


2. How to Identify a Path

   As defined in [RFC4271], a path refers to the information reported in
   the path attribute field of an UPDATE message.  As the procedures
   specified in [RFC4271] allow only the advertisement of one path for a
   particular address prefix, a path for an address prefix from a BGP
   peer can be keyed on the address prefix.

   In order for a BGP speaker to advertise multiple paths for the same
   address prefix, a new identifier (termed "Path Identifier" hereafter)
   needs to be introduced so that a particular path for an address
   prefix can be identified by the combination of the address prefix and
   the Path Identifier.

   The assignment of the Path Identifier for a path by a BGP speaker is
   purely a local matter.  However, the Path Identifier MUST be assigned
   in such a way that the BGP speaker is able to use the (prefix, path
   identifier) to uniquely identify a path advertised to a neighbor.  A
   BGP speaker that re-advertises a route MUST generate its own Path
   Identifier to be associated with the re-advertised route.  A BGP
   speaker that receives a route SHOULD NOT assume that the identifier
   carries any particular semantics; it SHOULD be treated as an opaque
   value.


3. Extended NLRI Encodings

   In order to carry the Path Identifier in an UPDATE message, the
   existing NLRI encodings are extended by prepending the Path
   Identifier field, which is of four-octets.

   For example, the NLRI encodings specified in [RFC4271, RFC4760] are
   extended as the following:


               +--------------------------------+
               | Path Identifier (4 octets)     |
               +--------------------------------+
               | Length (1 octet)               |
               +--------------------------------+
               | Prefix (variable)              |
               +--------------------------------+


   and the NLRI encoding specified in [RFC3107] is extended as the
   following:





Walton, et al        Expiration Date February 2011              [Page 3]


INTERNET DRAFT      draft-ietf-idr-add-paths-04.txt          August 2010


               +--------------------------------+
               | Path Identifier (4 octets)     |
               +--------------------------------+
               | Length (1 octet)               |
               +--------------------------------+
               | Label (3 octets)               |
               +--------------------------------+
               | ...                            |
               +--------------------------------+
               | Prefix (variable)              |
               +--------------------------------+


   The usage of the extended NLRI encodings is specified in the
   Operation section.


4. ADD-PATH Capability

   The ADD-PATH Capability is a new BGP capability [RFC5492].  The
   Capability Code for this capability is specified in the IANA
   Considerations section of this document. The Capability Length field
   of this capability is variable. The Capability Value field consists
   of one or more of the following tuples:


             +------------------------------------------------+
             | Address Family Identifier (2 octets)           |
             +------------------------------------------------+
             | Subsequent Address Family Identifier (1 octet) |
             +------------------------------------------------+
             | Send/Receive (1 octet)                         |
             +------------------------------------------------+


   The meaning and use of the fields are as follows:

       Address Family Identifier (AFI):

          This field is the same as the one used in [RFC4760].

       Subsequent Address Family Identifier (SAFI):

          This field is the same as the one used in [RFC4760].

       Send/Receive:

          This field indicates whether the sender is (a) willing to



Walton, et al        Expiration Date February 2011              [Page 4]


INTERNET DRAFT      draft-ietf-idr-add-paths-04.txt          August 2010


          receive multiple paths from its peer (value 1), (b) would
          like to send multiple paths to its peer (value 2), or (c)
          both (value 3) for the <AFI, SAFI>.


5. Operation

   The Path Identifier specified in the previous section can be used to
   advertise multiple paths for the same address prefix without
   subsequent advertisements replacing the previous ones.  Apart from
   the fact that this is now possible, the route advertisement rules of
   [RFC4271] are not changed.  In particular, a new advertisement for a
   given address prefix and a given path identifier replaces a previous
   advertisement for the given address prefix and the given path
   identifier.

   A BGP speaker that is willing to receive multiple paths from its
   peer, or would like to send multiple paths to its peer, SHOULD
   advertise the ADD-PATH Capability to the peer using BGP Capabilities
   advertisement [RFC5492].

   A BGP speaker MUST follow the existing procedures in generating an
   UPDATE message for a particular <AFI, SAFI> to a peer unless the BGP
   speaker advertises the ADD-PATH Capability to the peer indicating its
   desire to send multiple paths for the <AFI, SAFI>, and also receives
   the ADD-PATH Capability from the peer indicating its willingness to
   receive multiple paths for the <AFI, SAFI>, in which case the speaker
   MUST generate a route update for the <AFI, SAFI> based on the
   combination of the address prefix and the Path Identifier, and use
   the extended NLRI encodings specified in this document.  The peer
   SHALL act accordingly in processing an UPDATE message related to a
   particular <AFI, SAFI>.

   As the Path Identifiers are locally assigned, and may or may not be
   persistent across a control plane restart of a BGP speaker, an
   implementation SHOULD take special care so that the underlying
   forwarding plane of a "Receiving Speaker" as described in [RFC4724]
   is not affected during the graceful restart of a BGP session.













Walton, et al        Expiration Date February 2011              [Page 5]


INTERNET DRAFT      draft-ietf-idr-add-paths-04.txt          August 2010


6. Applications

   The BGP extension specified in this document can be used by a BGP
   speaker to advertise multiple paths in certain applications.  The
   availability of the additional paths can help reduce or eliminate
   persistent route oscillations [RFC3345].  It can also help with
   optimal routing and routing convergence in a network.  The
   applications are detailed in separate documents.


7. Deployment Considerations

   The extension proposed in this document provides a mechanism for a
   BGP speaker to advertise multiple paths over a BGP session.  Care
   needs to be taken in its deployment to ensure consistent routing and
   forwarding in a network, the details of which will be described in
   separate application documents.


8. IANA Considerations

   IANA has assigned capability number 69 for the ADD-PATH Capability
   described in this document.  This registration is in the BGP
   Capability Codes registry.


9. Security Considerations

   This document introduces no new security concerns to BGP or other
   specifications referenced in this document.


10. Acknowledgments

   We would like to thank David Cook and Naiming Shen for their
   contributions to the design and development of the extension.

   Many people have made valuable comments and suggestions, including
   Rex Fernando, Eugene Kim, Danny McPherson, Dave Meyer, Pradosh
   Mohapatra, Keyur Patel, Robert Raszuk, Eric Rosen, Srihari Sangli,
   Dan Tappan, and Mark Turner.










Walton, et al        Expiration Date February 2011              [Page 6]


INTERNET DRAFT      draft-ietf-idr-add-paths-04.txt          August 2010


11. References


11.1. Normative References

   [RFC4271] Rekhter, Y., T. Li, and S. Hares, "A Border Gateway
   Protocol 4 (BGP-4)," RFC 4271, January 2006.

   [RFC5492] Scudder, J. and R. Chandra, "Capabilities Advertisement
   with BGP-4", RFC 5492, February 2009.

   [RFC4760] Bates, T., Chandra, R., Rekhter, Y., and D. Katz,
   "Multiprotocol Extensions for BGP-4", RFC 4760, January 2007.

   [RFC3107] Rekhter, R. and E. Rosen, "Carrying Label Information in
   BGP-4," RFC 3107, May 2001.

   [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
   Requirement Levels," RFC 2119, BCP 14, March 1997.

   [RFC4724] Sangli, S., E. Chen, R. Fernando, J. Scudder, and Y.
   Rekhter, "Graceful Restart Mechanism for BGP", RFC 4724, January
   2007.


11.2. Informative References

   [RFC3345] McPherson, D., V. Gill, D. Walton, and A. Retana, "Border
   Gateway Protocol (BGP) Persistent Route Oscillation Condition", RFC
   3345, August 2002.


12. Authors' Addresses

   Daniel Walton
   Cisco Systems, Inc.
   7025 Kit Creek Rd.
   Research Triangle Park, NC 27709

   Email: dwalton@cisco.com


   Alvaro Retana
   Cisco Systems, Inc.
   7025 Kit Creek Rd.
   Research Triangle Park, NC 27709

   Email: aretana@cisco.com



Walton, et al        Expiration Date February 2011              [Page 7]


INTERNET DRAFT      draft-ietf-idr-add-paths-04.txt          August 2010


   Enke Chen
   Cisco Systems, Inc.
   170 W. Tasman Dr.
   San Jose, CA 95134

   Email: enkechen@cisco.com


   John Scudder
   Juniper Networks

   Email: jgs@juniper.net







































Walton, et al        Expiration Date February 2011              [Page 8]