BIER Source Protection
draft-zhang-bier-source-protection-00
|
| Document |
Type |
|
Active Internet-Draft (individual)
|
|
Last updated |
|
2019-07-07
|
|
Stream |
|
(None)
|
|
Intended RFC status |
|
(None)
|
|
Formats |
|
plain text
pdf
htmlized
bibtex
|
| Stream |
Stream state |
|
(No stream defined) |
|
Consensus Boilerplate |
|
Unknown
|
|
RFC Editor Note |
|
(None)
|
| IESG |
IESG state |
|
I-D Exists
|
|
Telechat date |
|
|
|
Responsible AD |
|
(None)
|
|
Send notices to |
|
(None)
|
BIER WG Zheng. Zhang
Internet-Draft Greg. Mirsky
Intended status: Informational Quan. Xiong
Expires: January 8, 2020 ZTE Corporation
July 7, 2019
BIER Source Protection
draft-zhang-bier-source-protection-00
Abstract
This document describes the multicast source protection functions in
Bit Index Explicit Replication BIER domain.
Status of This Memo
This Internet-Draft is submitted in full conformance with the
provisions of BCP 78 and BCP 79.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF). Note that other groups may also distribute
working documents as Internet-Drafts. The list of current Internet-
Drafts is at https://datatracker.ietf.org/drafts/current/.
Internet-Drafts are draft documents valid for a maximum of six months
and may be updated, replaced, or obsoleted by other documents at any
time. It is inappropriate to use Internet-Drafts as reference
material or to cite them other than as "work in progress."
This Internet-Draft will expire on January 8, 2020.
Copyright Notice
Copyright (c) 2019 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(https://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Zhang, et al. Expires January 8, 2020 [Page 1]
Internet-Draft BIER Source Protection July 2019
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2
2. Multicast Source Protection . . . . . . . . . . . . . . . . . 2
2.1. BIER Ping . . . . . . . . . . . . . . . . . . . . . . . . 3
2.2. BIER BFD . . . . . . . . . . . . . . . . . . . . . . . . 4
3. Security Considerations . . . . . . . . . . . . . . . . . . . 4
4. Normative References . . . . . . . . . . . . . . . . . . . . 4
Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 5
1. Introduction
Bit Index Explicit Replication (BIER) [RFC8279] is an architecture
that provides multicast forwarding through a "BIER domain" without
requiring intermediate routers to maintain any multicast related per-
flow state. BIER also does not require any explicit tree-building
protocol for its operation. A multicast data packet enters a BIER
domain at a "Bit-Forwarding Ingress Router" (BFIR), and leaves the
BIER domain at one or more "Bit-Forwarding Egress Routers" (BFERs).
To protect the source node it may be transmitting to two or more
BFIRs. Based on local policies, BFERs may elect to use the same BFIR
or different BFIRs as the source of the multicast flow. The BFIR and
the path in use are referred to as working while all alternative
available BFIRs and paths that can be used to receive the same
multicast flow are referred to as protection. For a BFER, when
either the working BFIR or the working path fail, the BFER can select
one of protection BFIRs to get the multicast flow. The shorter the
detection time is, the faster the flow recovers.
This document discusses the functions that can be used in failure
detection for multicast source protection.
2. Multicast Source Protection
Two BFIRs independently advertise the source of the multicast flow to
BFERs. The precise type of advertisement depends on the overlay
protocol being used, e.g., MLD, MVPN, EVPN. BFER selects one BFIR as
the UMH (Upstream Multicast Hop). Different BFERs may select the
same BFIR or different BFIRs according to the local policy.
Zhang, et al. Expires January 8, 2020 [Page 2]
Internet-Draft BIER Source Protection July 2019
+--------+S1+-------+
| |
+--v----+ +---v---+
+------+ BFIR1 | | BFIR2 +-------+
| +-------+ +-------+ |
| |
| |
| |
| +-------+ +-------+ +-------+ |
+--|BFER1|--------|BFER2|---- ---|BFER3|--+
+--+----+ +---+---+ +--+----+
| | |
v v v
R1 R2 R3
Figure 1
For example, a multicast source S1 is connected to BFIR1 and BFIR2.
BFIR1 and BFIR2 advertise the source information to BFERs. It is
assumed that BFER1, BFER2, and BFER3 all choose BFIR1 as the UMH.
BFERs signal to BFIR1 to get the multicast flow from S1.
In case BFIR1 fails, or the path from BFIR1 to BFER1 is broken, BFER1
should select BFIR2 as the UMH. But if the timeout period is too
long, the multicast flow will be significantly affected.
2.1. BIER Ping
[I-D.ietf-bier-ping] describes the mechanism and basic BIER OAM
packet format that can be used to perform failure detection and
isolation on BIER data plane without any dependency on other layers
like the IP layer.
In the example of Figure 1, BFER can monitor the status of BFIR and
the path status between BFER and BFIR. BFER1 sends the BIER Ping
packet to BFIR1. If BFER1 does not receive responses from BFIR1 in a
period of time, BFER1 will treat BFIR1 as a failed UMH, and BFER1
will select BFIR2 as the UMH and signal to BFIR2 to get multicast
flow.
In this example, BFER1, BFER2, and BFER3 send BIER ping packet to
BFIR1 separately. The timeout period MAY be set to a different
values depending on the local performance requirement on each BFER.
In general case of more complex BIER topology, it cannot be
guaranteed that the path used from BFIR1 to BFER1 is the same as in
the reverse direction, i.e., from BFER1 to BFIR1. If that is not
guaranteed and the paths are not co-routed, then this method may
produce false results, both false negative and false positive. The
Zhang, et al. Expires January 8, 2020 [Page 3]
Internet-Draft BIER Source Protection July 2019
former is when ping fails while the multicast path and flow are OK.
The latter is when the multicast path has defect but ping works.
Thus, to improve consistency of this method of detecting a failure in
multicast flow transport, the path that the echo request from BFER1
traverses to BFIR1 must be co-routed with the path that the monitored
multicast flow traverses through the BIER domain from BFIR1 to BFER1.
2.2. BIER BFD
[I-D.hu-bier-bfd] describes the application of P2MP BFD in BIER
network. And it describes the procedures for using such mode of BFD
protocol to verify multipoint or multicast connectivity between a
sender (BFIR) and one or more receivers (BFERs).
In the same example, BFIR1 sends the BIER Echo request packet to
BFERs to bootstrap a p2mp BFD session. After BFER1, BFER2 and BFER3
receive the Echo request packet with BFD Discriminator and the Target
SI-Bitstring TLVs, BFERs creates the BFD session of type
MultipointTail [RFC8562] to monitor the status of BFIR1 and the
working path. If BFERs have not received BFD packet from BFER1 for
the Detection Time [RFC8562], BFER1 will treat BFIR1 as a failed UMH,
and signal to BFIR2 to get the multicast flow.
The timeout period on each BFER MAY be set to different value
depending on the local performance requirement on each BFER. BFER
monitors BFIR separately and selects its UMH independently from
selections reached by other BFERs.
3. Security Considerations
Security considerations discussed in [RFC8279], [RFC8562],
[I-D.ietf-bier-ping] and [I-D.hu-bier-bfd] apply to this document.
4. Normative References
[I-D.hu-bier-bfd]
Xiong, Q., Mirsky, G., hu, f., and C. Liu, "BIER BFD",
draft-hu-bier-bfd-04 (work in progress), July 2019.
[I-D.ietf-bier-ping]
Kumar, N., Pignataro, C., Akiya, N., Zheng, L., Chen, M.,
and G. Mirsky, "BIER Ping and Trace", draft-ietf-bier-
ping-05 (work in progress), April 2019.
Zhang, et al. Expires January 8, 2020 [Page 4]
Internet-Draft BIER Source Protection July 2019
[RFC8279] Wijnands, IJ., Ed., Rosen, E., Ed., Dolganow, A.,
Przygienda, T., and S. Aldrin, "Multicast Using Bit Index
Explicit Replication (BIER)", RFC 8279,
DOI 10.17487/RFC8279, November 2017,
<https://www.rfc-editor.org/info/rfc8279>.
[RFC8562] Katz, D., Ward, D., Pallagatti, S., Ed., and G. Mirsky,
Ed., "Bidirectional Forwarding Detection (BFD) for
Multipoint Networks", RFC 8562, DOI 10.17487/RFC8562,
April 2019, <https://www.rfc-editor.org/info/rfc8562>.
Authors' Addresses
Zheng Zhang
ZTE Corporation
Email: zzhang_ietf@hotmail.com
Greg Mirsky
ZTE Corporation
Email: gregimirsky@gmail.com
Quan Xiong
ZTE Corporation
Email: xiong.quan@zte.com.cn
Zhang, et al. Expires January 8, 2020 [Page 5]