Multiple ALTO Resources Query Using Multipart Message
draft-zhang-alto-multipart-06
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Jingxuan Zhang , Y. Richard Yang | ||
Last updated | 2022-01-13 (Latest revision 2021-07-12) | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Many ALTO use cases involve multiple ALTO information resources like different network maps, cost maps and property maps to achieve their own specific goals. To make the ALTO client query them one by one is not only inefficient but also error-prone. The inconsistent responses can be performed because of the unstable communication environment, and finally conduct the unexpected traffic optimization. Further more, some ALTO information resources may have correlation, which means one's input parameters may depends on another one's response. To address those issues, some advanced query schema is required. This document proposes an ALTO extension to support the multiple ALTO resources query in the single request using the HTTP multipart message and the existing JSON query languages.
Authors
Jingxuan Zhang
Y. Richard Yang
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)