Multiple ALTO Resources Query Using Multipart Message
draft-zhang-alto-multipart-02

Document Type Expired Internet-Draft (individual)
Last updated 2019-09-26 (latest revision 2019-03-25)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-zhang-alto-multipart-02.txt

Abstract

Many ALTO use cases involve multiple ALTO information resources like different network maps, cost maps and property maps to achieve their own specific goals. To make the ALTO client query them one by one is not only inefficient but also error-prone. The inconsistent responses can be performed because of the unstable communication environment, and finally conduct the unexpected traffic optimization. Further more, some ALTO information resources may have correlation, which means one's input parameters may depends on another one's response. To address those issues, some advanced query schema is required. This document proposes an ALTO extension to support the multiple ALTO resources query in the single request using the HTTP multipart message and the existing JSON query languages.

Authors

J. Zhang (jingxuan.n.zhang@gmail.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)