Data Center Congestion Management requirements
draft-yueven-tsvwg-dccm-requirements-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Fei Chen , Wenhao Sun , Yolanda Yu , Roni Even | ||
Last updated | 2020-01-08 (Latest revision 2019-07-07) | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
On IP-routed datacenter networks, RDMA is deployed using RoCEv2 protocol or iWARP. RoCEv2 specification does not define a strong congestion management mechanisms and load balancing methods. RoCEv2 relies on the existing Link-Layer Flow-Control IEEE 802.1Qbb(Priority-based Flow Control, PFC) to provide a lossless fabric. RoCEv2 Congestion Management(RCM) use ECN(Explicit Congestion Notification, defined in RFC3168) to signal the congestion to the destination and use the congestion notification to reduce the rate of injection and increase the injection rate when the extent of congestion decreases. iWRAP depends on TCP congestion handling. This document describes the current state of flow control and congestion handling in the DC and provides requirements for new directions for better congestion control.
Authors
Fei Chen
Wenhao Sun
Yolanda Yu
Roni Even
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)