Application Oriented High Precision Delay and Jitter Measurement
draft-yang-ippm-ptp-measurement-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Hongwei Yang , Tao Sun , Kehan Yao | ||
| Last updated | 2021-01-13 (Latest revision 2020-07-12) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
As 5G has arisen and it is still evolving, there become many more time sensitive services which require high precision of measurements. In addition, in order to better simulate the transmission of packets of actual services, the length and priorities of the measurement packets SHOULD be customized, especially for some network that is inclined to get congested. This document introduces a new way to measure the time delay and jitter between two devices by making adjustments based on PTP Sync message and Delay_Req message, which could, to a great extent, get close to the messages of actual services as well as achieve high precison of measured metrics, so as to meet all requirements mentioned above.
Authors
Hongwei Yang
Tao Sun
Kehan Yao
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)