Factory default Setting
draft-wu-netconf-restconf-factory-restore-03

Document Type Expired Internet-Draft (individual)
Last updated 2019-04-14 (latest revision 2018-10-11)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Yang Validation 1 errors, 0 warnings.
Additional URLs
- Yang catalog entry for ietf-factory-reset@2018-10-09.yang
- Yang impact analysis for draft-wu-netconf-restconf-factory-restore
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-wu-netconf-restconf-factory-restore-03.txt

Abstract

This document defines a method to reset a YANG datastore to its factory-default content. The reset operation may be used e.g. during initial zero-touch configuration or when the existing configuration has major errors, so re-starting the configuration process from scratch is the best option. A new reset-datastore RPC is defined. Several methods of documenting the factory-default content are specified. Optionally a new "factory-default" read-only datastore is defined, that contains the data that will be copied over to the running datastore at reset.

Authors

Qin Wu (bill.wu@huawei.com)
Balázs Lengyel (balazs.lengyel@ericsson.com)
Ye Niu (niuye@huawei.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)