AAA Support for PMIP6 mobility entities Locating and Discovery during localized routing

Document Type Replaced Internet-Draft (individual)
Last updated 2010-04-12 (latest revision 2009-10-26)
Replaced by RFC 7156
Stream (None)
Intended RFC status (None)
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-dime-pmip6-lr
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


In Proxy Mobile IPv6, packets received from a Mobile Node (MN) by the the Mobile Access Gateway (MAG) to which it is attached are typically tunneled to a Local Mobility Anchor (LMA) for routing. The term "localized routing" refers to a method by which packets are routed directly by the MAG without involving the LMA. In order to establish a localized routing session between two Mobile Access Gateways in a Proxy Mobile IPv6 domain, two tasks must be accomplished: 1. The usage of local routing must be authorized for both MAGs and 2. The address of the MAG to which the Correspondent Node (CN) is attached must be discovered This document specifies how to accomplish these tasks using the Diameter protocol


Qin Wu (
Glen Zorn (

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)