Unified Identifier in IPv6 Segment Routing Networks
draft-wmsaxw-6man-usid-id-use-00

Document Type Expired Internet-Draft (individual)
Authors Weiqiang Cheng  , Shaofu Peng  , Liu Aihua  , Greg Mirsky  , XiaoLan Wan  , Cheng Wei  , Shay Zadok 
Last updated 2020-05-07 (latest revision 2019-11-04)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-wmsaxw-6man-usid-id-use-00.txt

Abstract

Segment Routing architecture leverages the paradigm of source routing. It can be realized in a network data plane by prepending the packet with a list of instructions, a.k.a. segments. A segment can be encoded as a Multi-Protocol Label Switching (MPLS) label, IPv4 address, or IPv6 address. Segment Routing can be applied in the MPLS data plane by encoding segments in an MPLS label stack. It also can be applied to the IPv6 data plane by encoding a list of segment identifiers in IPv6 Segment Routing Extension Header (SRH). In this document is described the use of unified segment identifiers in use cases where interworking between SR-MPLS and SRv6 is required.

Authors

Weiqiang Cheng (chengweiqiang@chinamobile.com)
Shaofu Peng (peng.shaofu@zte.com.cn)
Liu Aihua (liu.aihua@zte.com.cn)
Greg Mirsky (gregimirsky@gmail.com)
XiaoLan Wan (wxlan@h3c.com)
Cheng Wei (chengw@centecnetworks.com)
Shay Zadok (shay.zadok@broadcom.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)