"With-config-state" Capability for NETCONF/RESTCONF
draft-wilton-netmod-opstate-yang-02

Document Type Replaced Internet-Draft (individual)
Last updated 2016-06-23 (latest revision 2015-12-21)
Replaced by draft-nmdsdt-netmod-revised-datastores
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-nmdsdt-netmod-revised-datastores
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-wilton-netmod-opstate-yang-02.txt

Abstract

This document proposes a possible alternative solution for handling applied configuration state in YANG as described in draft-openconfig- netmod-opstate-01. The proposed solution, roughly modelled on the with-defaults NETCONF/RESTCONF capability, aims to meet the key requirements set out in draft-ietf-netmod-opstate-reqs-01 without the need for YANG module authors to explicitly duplicate configuration nodes in both configuration and operational containers. This draft does not address the issue of co-location of configuration and operational state for interfaces, nor does it provide a NETCONF mechanism to retrieve operational data separately from configuration data.

Authors

Robert Wilton (rwilton@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)