Skip to main content

How to Write an RTP Payload Format
draft-westerlund-avt-rtp-howto-00

Document Type Replaced Internet-Draft (individual)
Expired & archived
Author Magnus Westerlund
Last updated 2006-05-08 (Latest revision 2006-02-27)
Replaced by draft-ietf-avt-rtp-howto
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-avt-rtp-howto
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document contains information on how to best write an RTP payload format. Reading tips, design practices, and practical tips on how to quickly and with good results produce an RTP payload format specification. A template is also included with instructions that can be used when writing an RTP payload format.

Authors

Magnus Westerlund

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)