Dual-stack clients and merging of data from DHCPv4 and DHCPv6

Document Type Expired Internet-Draft (individual)
Authors Stig Venaas  , Tim Chown 
Last updated 2005-07-12
Stream (None)
Intended RFC status (None)
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


A node may have support for communications using both IPv4 and IPv6 protocols. Such a node may wish to obtain both IPv4 and IPv6 configuration settings via the Dynamic Host Configuration Protocol (DHCP). This can be done by using the IPv4 and the IPv6 DHC protocols respectively. This document considers mechanisms that allow such a node to make use of the configuration data from both protocols to obtain the desired common configuration.


Stig Venaas (venaas@uninett.no)
Tim Chown (tjc@ecs.soton.ac.uk)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)