An IPFIX-Based File Format
draft-trammell-ipfix-file-05
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Brian Trammell | ||
Last updated | 2012-10-29 (Latest revision 2007-11-08) | ||
Replaced by | draft-ietf-ipfix-file | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-ipfix-file | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a file format for the storage of flow data based upon the IPFIX message format. It proposes a set of requirements for flat-file, binary flow data file formats, then applies the IPFIX message format to these requirements to build a new file format. This IPFIX-based file format is designed to facilitate interoperability and reusability among a wide variety of flow storage, processing, and analysis tools.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)