Using Device-provided Location-Related Measurements in Location Configuration Protocols
draft-thomson-geopriv-held-measurements-06

Document Type Replaced Internet-Draft (individual)
Last updated 2010-08-24 (latest revision 2010-05-27)
Replaced by draft-ietf-geopriv-held-measurements
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-geopriv-held-measurements
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-thomson-geopriv-held-measurements-06.txt

Abstract

A method is described by which a Device is able to provide location- related measurement data to a LIS within a request for location information. Location-related measurement information are observations concerning properties related to the position of a Device, which could be data about network attachment or about the physical environment. When a LIS generates location information for a Device, information from the Device can improve the accuracy of the location estimate. A basic set of location-related measurements are defined, including common modes of network attachment as well as assisted Global Navigation Satellite System (GNSS) parameters.

Authors

Martin Thomson (martin.thomson@andrew.com)
James Winterbottom (james.winterbottom@andrew.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)