Guidelines for DiffServ to IEEE 802.11 Mapping
draft-szigeti-tsvwg-ieee-802-11-02
Document | Type |
Replaced Internet-Draft
(candidate for tsvwg WG)
Expired & archived
|
|
---|---|---|---|
Authors | Tim Szigeti , Fred Baker | ||
Last updated | 2016-06-24 | ||
Replaced by | draft-ietf-tsvwg-ieee-802-11 | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | Call For Adoption By WG Issued | |
Document shepherd | (None) | ||
IESG | IESG state | Replaced by draft-ietf-tsvwg-ieee-802-11 | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
As internet traffic is increasingly sourced-from and destined-to wireless endpoints, it is crucial that Quality of Service be aligned between wired and wireless networks; however, this is not always the case by default. This is due to the fact that two independent standards bodies provide QoS guidance on wired and wireless networks: specifically, the IETF specifies standards and design recommendations for wired IP networks, while a separate and autonomous standards- body, the IEEE, administers the standards for wireless 802.11 networks. The purpose of this document is to propose a set Differentiated Services Code Point (DSCP) to IEEE 802.11 User Priority (UP) mappings to reconcile the marking recommendations offered by these two standards bodies, and, as such, to optimize wired-and-wireless interconnect QoS.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)