Stream Control Transmission Protocol (SCTP) Stream Reset
draft-stewart-sctpstrrst-05
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Randall R. Stewart | ||
Last updated | 2007-06-28 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Many applications that desire to use SCTP have requested the ability to "reset" a stream. The intention of resetting a stream is to start the numbering sequence of the stream back at 'zero' with a corresponding notification to the upper layer that this act as been performed. The applications that have requested this feature normally desire it so that they can "re-use" streams for different purposes but still utilize the stream sequence number for the application to track the message flows. Thus, without this feature, a new use on an old stream would result in message numbers larger than expected without a protocol mechanism to "start the streams back at zero". This documents presents also a method for resetting the transport sequence numbers and all stream sequence numbers.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)