Dynamic Parameters Signaling for MPLS-based Pseudowires
draft-shah-pwe3-control-protocol-extension-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Himanshu C. Shah | ||
Last updated | 2003-07-01 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a mechanism along with extensions to [PWE3- CONTROL] draft that enable a PE to signal to the remote PE additional dynamic information about the pseudowire. This information may either be related to the operations of the pseudowire such as operational state of the Attachment circuit, the state of the pseudowire forwarders, the IP address and/or MAC address of the attached CE, or may affect the setup of the pseudowire, such as traffic engineering parameters, security related information, etc.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)