Skip to main content

Using QUIC Datagrams with HTTP/3
draft-schinazi-masque-h3-datagram-00

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Author David Schinazi
Last updated 2020-12-12
Replaced by draft-ietf-masque-h3-datagram, draft-ietf-masque-h3-datagram, draft-ietf-masque-h3-datagram, RFC 9297
RFC stream (None)
Formats
Additional resources
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state I-D Exists
Telechat date (None)
Responsible AD (None)
Send notices to (None)
draft-schinazi-masque-h3-datagram-00
Network Working Group                                        D. Schinazi
Internet-Draft                                                Google LLC
Intended status: Standards Track                        12 December 2020
Expires: 15 June 2021

                    Using QUIC Datagrams with HTTP/3
                  draft-schinazi-masque-h3-datagram-00

Abstract

   The QUIC DATAGRAM extension provides application protocols running
   over QUIC with a mechanism to send unreliable data while leveraging
   the security and congestion-control properties of QUIC.  However,
   QUIC DATAGRAM frames do not provide a means to demultiplex
   application contexts.  This document defines how to use QUIC DATAGRAM
   frames when the application protocol running over QUIC is HTTP/3 by
   adding an identifier at the start of the frame payload.

   Discussion of this work is encouraged to happen on the MASQUE IETF
   mailing list (masque@ietf.org (mailto:masque@ietf.org)) or on the
   GitHub repository which contains the draft:
   https://github.com/DavidSchinazi/draft-h3-datagram.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at https://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on 15 June 2021.

Copyright Notice

   Copyright (c) 2020 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

Schinazi                  Expires 15 June 2021                  [Page 1]
Internet-Draft              HTTP/3 Datagrams               December 2020

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents (https://trustee.ietf.org/
   license-info) in effect on the date of publication of this document.
   Please review these documents carefully, as they describe your rights
   and restrictions with respect to this document.  Code Components
   extracted from this document must include Simplified BSD License text
   as described in Section 4.e of the Trust Legal Provisions and are
   provided without warranty as described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   2
     1.1.  Conventions and Definitions . . . . . . . . . . . . . . .   3
   2.  HTTP/3 DATAGRAM Frame Format  . . . . . . . . . . . . . . . .   3
     2.1.  Flow Identifiers  . . . . . . . . . . . . . . . . . . . .   3
   3.  Flow Identifier Allocation  . . . . . . . . . . . . . . . . .   4
   4.  The H3_DATAGRAM HTTP/3 SETTINGS Parameter . . . . . . . . . .   4
   5.  Security Considerations . . . . . . . . . . . . . . . . . . .   5
   6.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .   5
   7.  Normative References  . . . . . . . . . . . . . . . . . . . .   5
   Acknowledgments . . . . . . . . . . . . . . . . . . . . . . . . .   6
   Author's Address  . . . . . . . . . . . . . . . . . . . . . . . .   6

1.  Introduction

   The QUIC DATAGRAM extension [DGRAM] provides application protocols
   running over QUIC [QUIC] with a mechanism to send unreliable data
   while leveraging the security and congestion-control properties of
   QUIC.  However, QUIC DATAGRAM frames do not provide a means to
   demultiplex application contexts.  This document defines how to use
   QUIC DATAGRAM frames when the application protocol running over QUIC
   is HTTP/3 [H3] by adding an identifier at the start of the frame
   payload.

   This design mimics the use of Stream Types in HTTP/3, which provide a
   demultiplexing identifier at the start of each unidirectional stream.

   Discussion of this work is encouraged to happen on the MASQUE IETF
   mailing list (masque@ietf.org (mailto:masque@ietf.org)) or on the
   GitHub repository which contains the draft:
   https://github.com/DavidSchinazi/draft-h3-datagram.

Schinazi                  Expires 15 June 2021                  [Page 2]
Internet-Draft              HTTP/3 Datagrams               December 2020

1.1.  Conventions and Definitions

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and
   "OPTIONAL" in this document are to be interpreted as described in BCP
   14 [RFC2119] [RFC8174] when, and only when, they appear in all
   capitals, as shown here.

2.  HTTP/3 DATAGRAM Frame Format

   When used with HTTP/3, the Datagram Data field of QUIC DATAGRAM
   frames uses the following format:

    0                   1                   2                   3
    0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |                     Flow Identifier (i)                     ...
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |                 HTTP/3 Datagram Payload (*)                 ...
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+

                   Figure 1: HTTP/3 DATAGRAM Frame Format

   Flow Identifier:  A variable-length integer indicating the Flow
      Identifier of the datagram (see Section 2.1).

   HTTP/3 Datagram Payload:  The payload of the datagram, whose
      semantics are defined by individual applications.

2.1.  Flow Identifiers

   Flow identifiers represent bidirectional flows of datagrams within a
   single QUIC connection.  These are conceptually similar to streams in
   the sense that they allow multiplexing of application data.  Of
   course flows lack any of the ordering or reliability guarantees of
   streams.

   Beyond this, a sender SHOULD ensure that DATAGRAM frames within a
   single flow are transmitted in order relative to one another.  If
   multiple DATAGRAM frames can be packed into a single QUIC packet, the
   sender SHOULD group them by flow identifier to promote fate-sharing
   within a specific flow and improve the ability to process batches of
   datagram messages efficiently on the receiver.

Schinazi                  Expires 15 June 2021                  [Page 3]
Internet-Draft              HTTP/3 Datagrams               December 2020

3.  Flow Identifier Allocation

   Implementations of HTTP/3 that support the DATAGRAM extension MUST
   provide a flow identifier allocation service.  That service will
   allow applications co-located with HTTP/3 to request a unique flow
   identifier that they can subsequently use for their own purposes.
   The HTTP/3 implementation will then parse the flow identifier of
   incoming DATAGRAM frames and use it to deliver the frame to the
   appropriate application.

   Even flow identifiers are client-initiated, while odd flow
   identifiers are server-initiated.  This means that an HTTP/3 client
   implementation of the flow identifier allocation service MUST only
   provide even identifiers, while a server implementation MUST only
   provide odd identifiers.  Note that, once allocated, any flow
   identifier can be used by both client and server - only allocation
   carries separate namespaces to avoid requiring synchronization.

4.  The H3_DATAGRAM HTTP/3 SETTINGS Parameter

   Implementations of HTTP/3 that support this mechanism can indicate
   that to their peer by sending the H3_DATAGRAM SETTINGS parameter with
   a value of 1.  The value of the H3_DATAGRAM SETTINGS parameter MUST
   be either 0 or 1.  A value of 0 indicates that this mechanism is not
   supported.  An endpoint that receives the H3_DATAGRAM SETTINGS
   parameter with a value that is neither 0 or 1 MUST terminate the
   connection with error H3_SETTINGS_ERROR.

   And endpoint that sends the H3_DATAGRAM SETTINGS parameter with a
   value of 1 MUST send the max_datagram_frame_size QUIC Transport
   Parameter [DGRAM].  An endpoint that receives the H3_DATAGRAM
   SETTINGS parameter with a value of 1 on a QUIC connection that did
   not also receive the max_datagram_frame_size QUIC Transport Parameter
   MUST terminate the connection with error H3_SETTINGS_ERROR.

   When clients use 0-RTT, they MAY store the value of the server's
   H3_DATAGRAM SETTINGS parameter.  Doing so allows the client to use
   HTTP/3 datagrams in 0-RTT packets.  When servers decide to accept
   0-RTT data, they MUST send a H3_DATAGRAM SETTINGS parameter greater
   or equal to the value they sent to the client in the connection where
   they sent them the NewSessionTicket message.  If a client stores the
   value of the H3_DATAGRAM SETTINGS parameter with their 0-RTT state,
   they MUST validate that the new value of the H3_DATAGRAM SETTINGS
   parameter sent by the server in the handshake is greater or equal to
   the stored value; if not, the client MUST terminate the connection
   with error H3_SETTINGS_ERROR.

Schinazi                  Expires 15 June 2021                  [Page 4]
Internet-Draft              HTTP/3 Datagrams               December 2020

5.  Security Considerations

   This document currently does not have additional security
   considerations beyond those defined in [QUIC] and [DGRAM].

6.  IANA Considerations

   This document will request IANA to register the following entry in
   the "HTTP/3 Settings" registry:

     +--------------+-------+---------------+---------+
     | Setting Name | Value | Specification | Default |
     +==============+=======+===============+=========+
     | H3_DATAGRAM  | 0x276 | This Document |    0    |
     +--------------+-------+---------------+---------+

7.  Normative References

   [DGRAM]    Pauly, T., Kinnear, E., and D. Schinazi, "An Unreliable
              Datagram Extension to QUIC", Work in Progress, Internet-
              Draft, draft-ietf-quic-datagram-01, 24 August 2020,
              <http://www.ietf.org/internet-drafts/draft-ietf-quic-
              datagram-01.txt>.

   [H3]       Bishop, M., "Hypertext Transfer Protocol Version 3
              (HTTP/3)", Work in Progress, Internet-Draft, draft-ietf-
              quic-http-32, 20 October 2020, <http://www.ietf.org/
              internet-drafts/draft-ietf-quic-http-32.txt>.

   [QUIC]     Iyengar, J. and M. Thomson, "QUIC: A UDP-Based Multiplexed
              and Secure Transport", Work in Progress, Internet-Draft,
              draft-ietf-quic-transport-32, 20 October 2020,
              <http://www.ietf.org/internet-drafts/draft-ietf-quic-
              transport-32.txt>.

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119,
              DOI 10.17487/RFC2119, March 1997,
              <https://www.rfc-editor.org/info/rfc2119>.

   [RFC8174]  Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC
              2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174,
              May 2017, <https://www.rfc-editor.org/info/rfc8174>.

Schinazi                  Expires 15 June 2021                  [Page 5]
Internet-Draft              HTTP/3 Datagrams               December 2020

Acknowledgments

   The DATAGRAM frame identifier was previously part of the DATAGRAM
   frame definition itself, the author would like to acknowledge the
   authors of that document and the members of the IETF QUIC working
   group for their suggestions.  Additionally, the author would like to
   thank Martin Thomson for suggesting the use of an HTTP/3 SETTINGS
   parameter.

Author's Address

   David Schinazi
   Google LLC
   1600 Amphitheatre Parkway
   Mountain View, California 94043,
   United States of America

   Email: dschinazi.ietf@gmail.com

Schinazi                  Expires 15 June 2021                  [Page 6]