Simple IPv6-in-IPv4 Tunnel Establishment Procedure (STEP)
draft-savola-v6ops-conftun-setup-02
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Pekka Savola | ||
| Last updated | 2004-01-29 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This memo describes a set of operational procedures, a UDP encapsulation for configured tunnels, and one implementation mechanism to provide a very simple and straightforward way to easily manage IPv6-over-IPv4 configured tunnels between an ISP and a customer. The configured tunnels work even if the IPv4 addresses change dynamically, or are private addresses; the procedure provides at least a /64 prefix per customer and requires no administrative set-up. NAT traversal is also supported.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)