MVPN: Optimized use of PIM via MS-PMSIs

Document Type Expired Internet-Draft (individual)
Last updated 2012-08-09 (latest revision 2012-02-06)
Stream (None)
Intended RFC status (None)
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


This document specifies an optimized method that a service provider can use to provide MVPN service when using PIM as the MVPN control protocol. As in prior MVPN methods, PIM control messages are sent over multicast tunnels through the provider network. However, unlike older MVPN methods, the tunnels are only created if they are needed to carry multicast data traffic; no tunnels are used only for control traffic.


Yiqun Cai (
Eric Rosen (
IJsbrand Wijnands (
Maria Napierala (
Arjen Boers (

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)