Distributed Denial-of-Service Open Threat Signaling (DOTS) Telemetry
draft-reddy-dots-telemetry-04

Document Type Active Internet-Draft (individual)
Last updated 2019-10-18
Stream (None)
Intended RFC status (None)
Formats plain text xml pdf htmlized bibtex
Yang Validation 0 errors, 0 warnings.
Additional URLs
- Yang catalog entry for ietf-dots-telemetry@2019-10-14.yang
- Yang impact analysis for draft-reddy-dots-telemetry
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
On Agenda dots at IETF-106
RFC Editor Note (None)
IESG IESG state I-D Exists
Telechat date
Responsible AD (None)
Send notices to (None)
DOTS                                                            T. Reddy
Internet-Draft                                                    McAfee
Intended status: Standards Track                            M. Boucadair
Expires: April 20, 2020                                           Orange
                                                                E. Doron
                                                            Radware Ltd.
                                                                 M. Chen
                                                                    CMCC
                                                        October 18, 2019

  Distributed Denial-of-Service Open Threat Signaling (DOTS) Telemetry
                     draft-reddy-dots-telemetry-04

Abstract

   This document aims to enrich DOTS signal channel protocol with
   various telemetry attributes allowing optimal DDoS attack mitigation.
   This document specifies the normal traffic baseline and attack
   traffic telemetry attributes a DOTS client can convey to its DOTS
   server in the mitigation request, the mitigation status telemetry
   attributes a DOTS server can communicate to a DOTS client, and the
   mitigation efficacy telemetry attributes a DOTS client can
   communicate to a DOTS server.  The telemetry attributes can assist
   the mitigator to choose the DDoS mitigation techniques and perform
   optimal DDoS attack mitigation.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at https://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on April 20, 2020.

Reddy, et al.            Expires April 20, 2020                 [Page 1]
Internet-Draft               DOTS Telemetry                 October 2019

Copyright Notice

   Copyright (c) 2019 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (https://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   3
   2.  Terminology . . . . . . . . . . . . . . . . . . . . . . . . .   5
   3.  DOTS Telemetry: Overview & Purpose  . . . . . . . . . . . . .   5
   4.  Generic Considerations  . . . . . . . . . . . . . . . . . . .   8
     4.1.  DOTS Client Identification  . . . . . . . . . . . . . . .   8
     4.2.  DOTS Gateways . . . . . . . . . . . . . . . . . . . . . .   8
   5.  DOTS Telemetry Attributes . . . . . . . . . . . . . . . . . .   9
     5.1.  Pre-mitigation DOTS Telemetry Attributes  . . . . . . . .   9
       5.1.1.  Total Traffic Normal Baseline . . . . . . . . . . . .   9
       5.1.2.  Total Pipe Capability . . . . . . . . . . . . . . . .   9
       5.1.3.  Total Attack Traffic  . . . . . . . . . . . . . . . .  10
       5.1.4.  Total Traffic . . . . . . . . . . . . . . . . . . . .  10
       5.1.5.  Total Connections Capacity  . . . . . . . . . . . . .  10
       5.1.6.  Total Attack Connections  . . . . . . . . . . . . . .  11
       5.1.7.  Attack Details  . . . . . . . . . . . . . . . . . . .  11
     5.2.  DOTS Client to Server Mitigation Efficacy DOTS Telemetry
           Attributes  . . . . . . . . . . . . . . . . . . . . . . .  13
       5.2.1.  Total Attack Traffic  . . . . . . . . . . . . . . . .  14
       5.2.2.  Attack Details  . . . . . . . . . . . . . . . . . . .  14
     5.3.  DOTS Server to Client Mitigation Status DOTS Telemetry
           Attributes  . . . . . . . . . . . . . . . . . . . . . . .  14
       5.3.1.  Mitigation Status . . . . . . . . . . . . . . . . . .  14
   6.  DOTS Telemetry Configuration  . . . . . . . . . . . . . . . .  14
     6.1.  Convey DOTS Telemetry Configuration . . . . . . . . . . .  14
     6.2.  Delete DOTS Telemetry Configuration . . . . . . . . . . .  17
   7.  DOTS Telemetry YANG Module  . . . . . . . . . . . . . . . . .  17
     7.1.  Tree Structure  . . . . . . . . . . . . . . . . . . . . .  17
     7.2.  YANG Module . . . . . . . . . . . . . . . . . . . . . . .  23
Show full document text