Skip to main content

Tunneling Header Compression (TuCP) for Tunneling over IP
draft-rawat-mext-hc-tunneling-00

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Priyanka Rawat , J-M Bonnin , Ana Minaburo , Eun Paik
Last updated 2009-03-26
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

The IP tunneling mechanisms have important applications in network solutions and are widely used in numerous contexts such as security (VPN), IPv4 to IPv6 transition, and mobility support (MobileIP and NEMO). However, these tunneling mechanisms induce a large overhead resulting from adding several protocol headers in each packet. This overhead deteriorates performance on wireless links which are scarce in resources. Header compression methods are often used on connection oriented communication (e.g., UMTS networks) to reduce the overhead on the wireless part. These header compression methods can be used on tunnel headers to reduce the protocol header overheads, independent of the payload type. Although, several header compression methods exist, the header compression profiles defined by them are not adapted to the characteristics of IP tunneling. This document specifies a tunneling header compression protocol for IP tunneling mechanisms.

Authors

Priyanka Rawat
J-M Bonnin
Ana Minaburo
Eun Paik

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)