DHCPv6 Active Leasequery
draft-raghuvanshi-dhc-dhcpv6-active-leasequery-00

Document Type Replaced Internet-Draft (individual)
Last updated 2013-10-04
Replaced by draft-ietf-dhc-dhcpv6-active-leasequery
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-dhc-dhcpv6-active-leasequery
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-raghuvanshi-dhc-dhcpv6-active-leasequery-00.txt

Abstract

The Dynamic Host Configuration Protocol for IPv6 (DHCPv6) has been extended with a Leasequery capability that allows a client to request information about DHCPv6 bindings. That mechanism is limited to queries for DHCPv6 binding data updates until the time DHCPv6 server receive the Leasequery request. Continuous update of an external client with Leasequery data is sometimes desired. This document expands on the DHCPv6 Leasequery protocol, and allows for active transfer of real-time DHCPv6 binding information data via TCP. This document also extends DHCPv6 Bulk Leasequery by adding new options.

Authors

Dushyant Raghuvanshi (draghuva@cisco.com)
Deepak Kukrety (dkukrety@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)