Multicast VPN with Segment Routing Point-to-Multipoint Segment
draft-parekh-bess-mvpn-sr-p2mp-00

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Authors Rishabh Parekh  , Clarence Filsfils  , Arvind Venkateswaran  , Hooman Bidgoli  , Dan Voyer  , Clayton Hassen
Last updated 2019-09-12 (latest revision 2019-03-11)
Replaced by draft-parekh-bess-mvpn-evpn-sr-p2mp
Stream (None)
Formats
Expired & archived
pdf htmlized bibtex
Additional Resources
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-parekh-bess-mvpn-sr-p2mp-00.txt

Abstract

A Point-to-Multipoint (P2MP) Segment in a Segment Routing domain efficiently carries traffic from a Root to a set of Leaves. This document describes extensions to BGP encodings and procedures for P2MP segments used in BGP/MPLS IP VPNs.

Authors

Rishabh Parekh (riparekh@cisco.com)
Clarence Filsfils (cfilsfil@cisco.com)
Arvind Venkateswaran (arvvenka@cisco.com)
Hooman Bidgoli (hooman.bidgoli@nokia.com)
Dan Voyer (daniel.voyer@bell.ca)
Clayton Hassen (clayton.hassen@bell.ca)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)