MPLS LDP Query Message Description

Document Type Expired Internet-Draft (individual)
Authors Peter Ashwood-Smith  , Antonela Paraschiv 
Last updated 2000-07-19
Stream (None)
Intended RFC status (None)
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


This document describes the encoding and procedures for two new LDP messages, the Query Message and Query-Reply Message. An LER sends a Query message when it needs to find out information about an LSP. The Query message is sent for an established LSP. The Query message can be used for LDP LSPs as well as for CR-LSPs. The queried data is encoded into the Query-Reply message and partially into the Query Message.


Peter Ashwood-Smith (
Antonela Paraschiv (

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)