Path Computation Element (PCE) Protocol Extensions for Stateful PCE usage for Point-to-Multipoint Traffic Engineering Label Switched Paths
draft-palle-pce-stateful-pce-p2mp-07

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Authors Udayasree Palle  , Dhruv Dhody  , Yosuke Tanaka  , Zafar Ali  , Vishnu Beeram 
Last updated 2015-12-31 (latest revision 2015-06-29)
Replaced by RFC 8623, RFC 8623
Stream (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Additional Resources
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-palle-pce-stateful-pce-p2mp-07.txt

Abstract

The Path Computation Element (PCE) has been identified as an appropriate technology for the determination of the paths of point- to-multipoint (P2MP) TE LSPs. This document provides extensions required for PCEP so as to enable the usage of a stateful PCE capability in supporting point-to-multipoint (P2MP) TE LSPs.

Authors

Udayasree Palle (udayasree.palle@huawei.com)
Dhruv Dhody (dhruv.ietf@gmail.com)
Yosuke Tanaka (yosuke.tanaka@ntt.com)
Zafar Ali (zali@cisco.com)
Vishnu Beeram (vbeeram@juniper.net)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)