Skip to main content

PCEP Extensions for PCE-initiated Point-to-Multipoint LSP Setup in a Stateful PCE Model
draft-palle-pce-stateful-pce-initiated-p2mp-lsp-07

Document Type Replaced Internet-Draft (individual)
Expired & archived
Authors Udayasree Palle , Dhruv Dhody , Yosuke Tanaka , Zafar Ali , Vishnu Pavan Beeram
Last updated 2016-01-10
Replaced by draft-palle-pce-stateful-pce-p2mp, draft-ietf-pce-stateful-pce-p2mp
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-pce-stateful-pce-p2mp, draft-palle-pce-stateful-pce-p2mp
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

The Path Computation Element (PCE) has been identified as an appropriate technology for the determination of the paths of point- to-multipoint (P2MP) TE LSPs. This document provides extensions required for Path Computation Element communication Protocol (PCEP) so as to enable the usage of a stateful PCE initiation capability in recommending P2MP TE LSP instantiation.

Authors

Udayasree Palle
Dhruv Dhody
Yosuke Tanaka
Zafar Ali
Vishnu Pavan Beeram

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)