PCEP Extensions for PCE-initiated Point-to-Multipoint LSP Setup in a Stateful PCE Model

Document Type Replaced Internet-Draft (individual)
Authors Udayasree Palle  , Dhruv Dhody  , Yosuke Tanaka  , Zafar Ali  , Vishnu Beeram 
Last updated 2016-01-10
Replaced by draft-palle-pce-stateful-pce-p2mp, RFC 8623
Stream (None)
Intended RFC status (None)
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-palle-pce-stateful-pce-p2mp, draft-ietf-pce-stateful-pce-p2mp
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


The Path Computation Element (PCE) has been identified as an appropriate technology for the determination of the paths of point- to-multipoint (P2MP) TE LSPs. This document provides extensions required for Path Computation Element communication Protocol (PCEP) so as to enable the usage of a stateful PCE initiation capability in recommending P2MP TE LSP instantiation.


Udayasree Palle (udayasree.palle@huawei.com)
Dhruv Dhody (dhruv.ietf@gmail.com)
Yosuke Tanaka (yosuke.tanaka@ntt.com)
Zafar Ali (zali@cisco.com)
Vishnu Beeram (vbeeram@juniper.net)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)