Routing Information Base Info Model
draft-nitinb-i2rs-rib-info-model-02
Document | Type |
Replaced Internet-Draft
(i2rs WG)
Expired & archived
|
|
---|---|---|---|
Authors | Nitin Bahadur , Ron Folkes , Sriganesh Kini , Jan Medved | ||
Last updated | 2013-09-16 (Latest revision 2013-08-21) | ||
Replaced by | draft-ietf-i2rs-rib-info-model | ||
RFC stream | Internet Engineering Task Force (IETF) | ||
Intended RFC status | (None) | ||
Formats | |||
Additional resources | Mailing list discussion | ||
Stream | WG state | WG Document | |
Document shepherd | (None) | ||
IESG | IESG state | Replaced by draft-ietf-i2rs-rib-info-model | |
Consensus boilerplate | Unknown | ||
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Routing and routing functions in enterprise and carrier networks are typically performed by network devices (routers and switches) using a routing information base (RIB). Protocols and configuration push data into the RIB and the RIB manager install state into the hardware; for packet forwarding. This draft specifies an information model for the RIB to enable defining a standardized data model. Such a data model can be used to define an interface to the RIB from an entity that may even be external to the network device. This interface can be used to support new use-cases being defined by the IETF I2RS WG.
Authors
Nitin Bahadur
Ron Folkes
Sriganesh Kini
Jan Medved
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)