Pseudowire Performance and Timing Measurement
draft-nadeau-pwe3-perf-timing-measure-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Thomas Nadeau , Yaakov (J) Stein | ||
| Last updated | 2006-02-28 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
To-date, no intrinsic mechanisms exist for pseudowires that allow operators to measure the performance of a pseudowire. Only the existing Virtual Circuit Connectivity Verification protocol allows for the verification of connectivity of a pseudowire. This document defines the problems that must be solved in this space, and provides discussion points around the issues of pseudowire performance measurement, including timing synchronization and packet loss detection.
Authors
Thomas Nadeau
Yaakov (J) Stein
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)