Optimized RIP for embedded RF networks
draft-mulligan-roll-ripless-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Geoffrey C. Mulligan | ||
| Last updated | 2010-03-08 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies an optimization to the Routing Information Protocol (RIP) routing protocol for use in embedded RF IPv6 internets such as those used in 6lowpan [7] networks. RIPless specifies the minimal changes to RIP, as specified in RIPng [2], RIP [3] and RIPv2 [4] to allow the protocol to be used in a "lossy" RF networks where the routing fabric of the network is built upon powered nodes and that only the edge devices may be battery powered.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)