TWAMP Reflect Padding Feature
draft-morton-ippm-twamp-reflect-padding-00
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Al Morton , Len Ciavattone | ||
| Last updated | 2008-07-07 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The IETF is completing its work on TWAMP - the Two-Way Active Measurement Protocol. This memo describes a proposed feature for TWAMP, intended for discussion in the IP Performance Metrics WG. The feature gives the reflector the ability to return some of the packet padding bits to the sender.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)